Overview
End fittings determine how a cable assembly connects to the final equipment, structure or moving component. A small difference in fitting type, thread, eye size or connection direction can change whether the assembly fits the application.
Gosor supports end fitting installation and configuration for wire rope assemblies, control cables, suspension kits, tool lanyards and gym equipment cables. Buyers can provide drawings, photos, samples or fitting descriptions for quotation review.
End Fitting Selection Summary
Start with the function of the cable end: loop protection, cable termination, equipment connection, adjustment or suspension. Common discussions include a thimble, sleeve, ferrule, swage terminal, threaded stud, ball end, loop end, hook, carabiner or cable gripper. The fitting name should be checked against the cable diameter, mating hardware and installation space.
Cable Diameter and Fitting Matching Notes
State the cable diameter before choosing a sleeve, ferrule, gripper or terminal. If the cable is coated, also identify the finished outside diameter where the fitting or guide must accept the cable. End A and End B may use different fittings, so label each photo or drawing separately.
Installation Space Confirmation
Show the equipment-side bracket, thread engagement area, slot, pin, pulley, guide or anchor point. A close-up of the fitting alone may not show the clearance or connection direction needed for assembly review. For replacement projects, include the used fitting and the mating part whenever possible.
End Fitting RFQ Checklist
- Cable diameter and coated outside diameter if known
- Fitting type and function at End A and End B
- Main dimensions, thread details and connection direction
- Installation-space or mating-hardware photos
- Drawing, sample, quantity and whether the fitting is loose or assembled
Read the Wire Rope End Fittings Guide, compare the Wire Rope Fittings category and send the prepared details through Request a Quote.
Common Mistakes
Avoid using “cable end fitting” as the only description. Do not assume a sleeve, ferrule and thimble perform the same function, and do not select a terminal before checking the equipment-side interface. Clear photos and reference dimensions reduce fitting clarification during RFQ review.