Overview
An OEM cable assembly request should make clear which mechanical assembly is being discussed, how it connects to the equipment, and what evidence defines the requested configuration. This application page helps purchasing and engineering teams organize that project information across the mechanical cable and steel wire-rope assembly families represented on the Gosor site. It is not an electrical wire-harness sourcing page, and it does not assume a material, rating, certification, quantity threshold or delivery schedule that has not been confirmed for the project.
Start with the assembly family
The equipment function and connection method determine which product route is most relevant. A routed mechanical control request may concern a Bowden cable, a push-pull cable or another control-and-brake assembly. A flexible steel cable request may instead be a terminated wire-rope assembly, a fitness cable or a suspension component. Start from the closest product category and keep similar-looking assemblies distinct until the movement, installation and end interfaces are clear.
For a control-cable sourcing brief, use Custom Mechanical Control Cables as the commercial owner; the Control & Brake Cables category and individual Bowden or push-pull product pages help narrow the configuration. For a terminated wire-rope requirement, start with the Wire Rope Assemblies category and the Wire Rope Assembly Manufacturer sourcing page. These routes keep the broad OEM project context separate from product-specific and supplier-intent questions.
Match the evidence to the project stage
For a new or revised design, attach the controlled drawing or BOM and identify its revision. For a replacement project, include a sample or clear photographs of the complete assembly, both ends and the equipment-side mating points. If only a sketch is available, mark the reference faces, centerlines and open dimensions instead of estimating them. A photo can support the conversation, but it should not silently replace a required drawing or buyer-defined acceptance criterion.
The Drawing-Based Cable Assembly service is relevant when the request starts from a drawing, BOM or measured sketch. The Sample-Based Cable Matching route helps organize a request that starts from an existing part. Keep the product reference and the project evidence together so a quotation discussion can distinguish the requested assembly from other variants.
Define interfaces and dimensions together
Record the cable or inner member, housing or casing, length reference points and end fitting details that are known. Identify End A and End B separately, show each mating interface and note whether an adjuster, bracket, sleeve or other component belongs to the assembly or the equipment. For a routed control cable, add the intended motion, housing support points and installation path. For a wire-rope assembly, show the cable-to-fitting transitions and the points used to describe its finished length.
Separate measured facts from assumptions. If a material, coating, diameter, tolerance, working load or test requirement is not confirmed, mark it as open for the responsible buyer or project owner to resolve. Do not infer performance or suitability from a product name or photograph alone. The same principle applies to a sample: visible fit does not establish unverified function, compliance or service life.
Keep revision, quantity and packaging with the request
State whether the inquiry is for a new design, replacement, sample review or a repeat-order reference. Give quantity by model or configuration where there are variants, and attach the drawing or project revision that the request should follow. If labeling, packaging, grouping by kit or requested records matter, include those details in the same RFQ package rather than adding them after the product has been defined.
For sample approval, the buyer or project owner should identify the sample, controlled revision, approval scope and any open deviations. Drawing review and sample approval are separate decisions; neither should be read as a Gosor-specific testing or approval process. The related buyer guides below provide supporting detail.
Move the project to the right RFQ path
Before submitting, identify the product family, application context, reference documents, known dimensions, end interfaces, quantity and packaging needs. State what is confirmed and what still needs supplier review. Then use Request a Quote with the drawing, BOM, sample photos or measured sketch that best represents the intended assembly.
The goal is a clear project handoff, not a claim that every OEM configuration is already a catalog item. Product-specific availability, material choices and other open requirements must be confirmed for the individual request.